Universal Macros
These macros will work on any size Troodon with any board.
Change Filament - Direct Drive Extruder
This macro should work on any Troodon with a Direct Drive Extruder regardless the version of RRF or the board.
The Hotend must be on Tool 0 which should be the case.
set the hotend to 210C
purge 10mm of filament at 5mm/s
retract 100mm of filament at 10mm/s
pause to allow changing the filament
extrude 70mm at 10mm/s
extrude 30mm at 5mm/s
set the hotend to 0C
Submitted by Fred L
Load Filament - Direct Drive Extruder
This macro should work on any Troodon with a Direct Drive Extruder regardless the version of RRF or the board.
The Hotend must be on Tool 0 which should be the case.
set the hotend to 210C
pause to allow changing the filament
extrude 70mm at 10mm/s
Extrude 30mm at 5mm/s
set the hotend to 0C
Submitted by Fred L
UnLoad Filament - Direct Drive Extruder
This macro should work on any Troodon with a Direct Drive Extruder regardless the version of RRF or the board.
The Hotend must be on Tool 0 which should be the case.
set the hotend to 210C
retract 100mm of filament at 10mm/s
Submitted by Fred L